HOW TO USE

• Usage
  New or reconditioned wood decks, porches, outdoor furniture, steps, railings, fences and siding.
• Prep
  Be sure surface is free of all dirt, mildew stains, loose wood fibers and other foreign matter. In order to be effective, a stain must be able to penetrate. Surfaces must be sound and may be dry or damp. If damp, the wood should be free of puddles and not feel wet. Prepare previously stained or weathered surfaces with Valspar® Wood Cleaner or Valspar® All-In-One Wood Prep. On untreated weathered surfaces, it is best to pressure wash, but at minimum, scrubbing with a stiff bristle brush and rinsing with a garden hose should be done to completely remove all loose wood fibers. Sanding is best to remove any loose wood fibers.
• Application
  Apply with nylon or polyester brushes, stain pads or professional spray equipment. When spraying, always back-brush immediately. To ensure desired appearance and proper drying time, always finish a small test area before proceeding. Do not overapply. Shake and stir thoroughly before and during use. If project requires more than 1 container, blend all containers together to ensure uniformity. Apply to small sections at a time (1–3 boards); start at one edge of the board and work end-to-end, following through to the end of the boards to avoid lap marks. A one-coat application is recommended.
• Dry Time
  Dry Time @ 77 °F and 50 % Relative Humidity
  To The Touch: 2 hour - 4 hour
  Recoat: 2 hour - 4 hour
• Clean-up & Disposal
  Clean up with soap and water. Do not freeze. Keep container closed when not in use. Do not transfer to other containers for storage or disposal. In case of spillage, absorb with inert material. Dispose in accordance with local, state and federal regulations.